Labsci 15+L Electronic Benchtop Autoclave Tuttnauer With Printer

LabSci 15+L Electronic Bench-top Autoclave Tuttnauer

Designed to autoclave everything in your lab, including liquids.

Sterilization of Liquids

The sterilization of liquids is different than sterilizing solid-state instruments. The heat distribution in a fluid can be higher or lower depending on the chemical make-up of the liquid. So, the temperature probes are there to make sure the chamber heats up to a point where the heat distribution in the liquid achieves sterilization temperature throughout. During the sterilization process, the pressurized chamber packs molecules in water-tight. After sterilization is achieved, the chamber is opened, and the chamber’s pressure and temperature begin to decrease. At this point, the molecules move away quickly, sometimes too quickly! If the chamber is not at a low enough temperature, the liquid will boil over. The probes regulate the temperature to prevent a boil-over.

Features

• No water utility connections are needed, just plug in and add water.
• Two integrated temperature probes for complete sterilization of liquids
• Four validated cycles (glass, plastic, liquid A and liquid B-waste).
• Stores up to 200 past cycles you can open on your PC
• Create up to 16 custom cycles!
• Two trays Included
• Optional Biohazard filter (BH) prevents contaminated air from exhausting into the lab
• Options that are available on all “LabSci“ models include Warming (95°C to 104°C), Isothermal (80°C to 94°C) F₀, 21 CFR with R.PC.R software, Biohazard filter and overpressure cycle to ensure sealed bags and containers do not break during the sterilization cycle.

Specifications

• Chamber Volume (L): 85
• Max Available Height (in): 12.1“
• Chamber Dimension (in): 15“ x 27.2“
• External Dimension (in): 28.3“ x 21.3“ x 37“
• Power: 230V, 3 phase (60 Hz) L15-30
  
• Utilities: No Plumbing Required
• Free autoclave stand included

Virus Protect

By heating the chamber for a set time prior to the sterilization process, Virus Protect destroys harmful viruses such as Covid 19, before the air removal stage from the chamber starts. This creates a protective shield that prevents the emission of bio-contaminants and viruses into the environment. This cycle has been developed based on academic research and literature, to ensure the complete and comprehensive elimination of viruses.

What is the difference between the 15L and 15+L?

15L is single phase 230V – 2 trays
The bottom tray is 12 x 18.6
The middle tray is 13 x 18.6

15+L is three phase 230V – 2 trays
The bottom tray is 12 x 26.6
The middle tray is 13 x 26.6

Choosing the right steam autoclave depends on several considerations: the type of loads, frequency of use, available services and load volumes. The Tuttnauer LabSci autoclave series successfully meets the challenges posed by sterilization in laboratories and research institutes.